| |||||||
| Registracija | FAQ | Lista korisnika | Kalendar | Pretraži | Današnje Poruke | Označi forume pročitanima | Online igre |
| Tutoriali i Trikovi Raspravljate o temi CATI-a V5R16....R17 u Tehnologija i Tehnika forumu; Odnosi se na sve trikove koje posjedujete u dotičnom programu..... Ruka ruku mije... |
 |
| | Opcije Teme |
10-11-06, 06:52
| #3 (permalink) |
| Starter Datum registracije: 27-09-06
Poruka: 8
 | CATI-a V5R16....R17 Korištenje funkcije trim (cut and assembles) umjesto join, rezultat je identičan no daljnje korištenje nakon funkcije trim daje veće mogučnosti tj.manje pojavljivanje naknadnih "grešaka" (kod služenijih geometrija)....isprobano.... 
__________________ Ruka ruku mije  |
|      |
|
10-11-06, 07:38
| #4 (permalink) |
| Starter Datum registracije: 27-09-06
Poruka: 8
| CATI-a V5R16....R17 Creating Swept Surfaces (koristite?!..naravno!!..) početnici i "početnici" vjerojatno manje....isplati se potrošiti vremena zbog te funkcije jer skračuje vrijeme i pojednostavljuje konstrukciju...naravno u Generative Shape Disign Creating Swept Surfaces: You can sweep an explicit profile: * along one or two guide curves (in this case the first guide curve is used as the spine by default) * along one or two guide curves while respecting a specified spine. The profile is swept out in planes normal to the spine. In addition, you can control the positioning of the profile while it is being swept by means of a reference surface. The profile position may be fixed with respect to the guide curve (positioned profile) or user-defined in the first sweep plane. You can sweep an implicit linear profile along a spine.This profile is defined by: * two guide curves and two length values for extrapolating the profile * a guide curve and a middle curve * a guide curve, a reference curve, an angle and two length values for extrapolating the profile * a guide curve, a reference surface, an angle and two length values for extrapolating the profile * a guide curve, and a reference surface to which the sweep is to be tangent * a guide curve and a draft direction You can sweep an implicit circular profile along a spine.This profile is defined by: * three guide curves * two guide curves and a radius value * a center curve and two angle values defined from a reference curve (that also defines the radius) * a center curve and a radius. You can sweep an implicit conical profile along a spine. This profile is defined by: * three guide curves * two guide curves and a radius value * a center curve and two angle values defined from a reference curve (that also defines the radius) * a center curve and a radius.
__________________ Ruka ruku mije Zadnji Uredio Crveni_VTLP : 10-11-06 u 07:43. |
|
| |
|
| Tagovi: catia, v5r16r17 |
| Broj korisnika koji trenutno prate ovu Temu: 1 (0 članova i 1 gosta) | |
| Opcije Teme | |
| |
Trenutno vrijeme na forumu: 12:56.